NEWS

Landscape lights are widely used in our daily lives, and their replacement time is very long. They are not replaced directly if there is a malfunction or something goes wrong, but are repaired and maintained multiple times within their usable range before being used again. So, what are the common problems with landscape lights? What are the daily maintenance methods for landscape lights? Let's take a look together with Jiuzheng Lighting Network!
What are the common problems with landscape lights
1. The construction quality is poor, and the proportion of faults is relatively large. The object of customized lighting for landscape lights is different from indoor lighting and building environmental lighting, and its main purpose is to enhance the scenery effect and create a night view. Therefore, in terms of the type of light source, it is advisable to choose a light source with good direction and control ability, and reduce the use of ordinary floodlighting fixtures. The main manifestations are: firstly, the depth of the cable trench is insufficient, and the construction of the covered sand bricks is not in accordance with the standards; The second issue is that the production and installation of aisle pipes do not meet the requirements, and the two ends are not made into whistles according to standards; When laying cables, drag them to the ground; Fourthly, the foundation buried pipes are not constructed according to standard requirements, mainly because the buried pipes are too thin and have certain bends, making it difficult to use cables, resulting in dead corners at the bottom of the foundation. Fifth, if the pressure on the wire head and the thickness of the insulation package are not sufficient, a short circuit will occur between phases after a long period of time.
2. Material failure, due to the failures dealt with in recent years, is also due to many factors such as low material quality. Its main performance is that the wire contains less aluminum, the wire is hard, and the insulation layer is thin. In recent years, this situation has become more common.
3. The quality of the support project is poor, and landscape light cables are generally laid on green belts. The construction quality of the road surface is poor, and the ground collapses, causing deformation of the cableway and causing cable armor. Especially in the Northeast region, which is located in a high cold region, winter brings the cables and soil into a whole. Once the ground subsides, it will be pulled to the base of the landscape lighting, while in summer, rainwater will burn at the base of the foundation.
4. Unreasonable design, on the one hand, is overload operation. The lighting requirements for customized landscape lights vary greatly from location to location. To showcase the beautiful shapes of buildings, sculptures, flowers, trees, mountains, and other scenery in the park, the lighting methods should vary depending on the scenery, and the projected lighting should also vary in intensity according to needs, in order to showcase their respective charm at night; The street lights on both sides of the garden road should have uniform and continuous illumination to meet safety needs. With the continuous development of urban construction, landscape lights are also constantly expanding. When a new landscape light is established, it is usually close to the landscape light and connected to which loop. In addition, in recent years, the advertising industry has developed rapidly, and the advertising load is connected to landscape lights, resulting in excessive load on landscape lights. Cable overheating, wire head overheating, insulation reduction, grounding short circuit, etc; On the other hand, when designing lamp poles, only their own situation is considered, ignoring the space of cable heads. After the cable head is wrapped, most of the doors are not closed, and sometimes the cable is not long enough, and the joint production does not meet the requirements. This is also the reason for the failure.